PROFESSIONAL DIRECT DRIVE TURNTABLEOWNER'S MANUALVESTAX CORPORATION1-18-16 Wakabayashi, Setagaya-ku, Tokyo 154-0023 JapanPhone : 03-3412-7011 Fa
9q Carefully release the tone arm from the tone arm clamp.Adjustment of Horizontal Zero BalanceA Tone arm height adjustment may be necessary for somec
10Fit the EP adapter over the center spindle and follow the sameplaying instructions as written above.A detachable stylus light is available for this
11e ULTRA PITCH FADERUsing the ultra pitch fader will allow you to make dramaticand accurate pitch adjustments up to +/-50%.Currently set amountAmount
12You can adjust the starting speed of the platter by adjusting theSPEED ADJUSTMENT 'START' dial. A clockwise rotationslows down the startin
12AZ851010SPECIFICATIONMOTOR START UP TIME STARTING TORQUE BRAKING SYSTEM RAMBLE( S/N RATIO ) SPEED FINE PITCH ULTRA PITCH PITCH BEND WOW & FLUTT
1Thank you for purchasing the Vestax PDX-2300, ProfessionalDirect Drive Turntable. Please read this owner's manual carefully,so that you will ful
21. Read instructions-All the safety and operating instructionsshould be read before the appliance is operated.2. Retain instructions-The safety and o
3FEATURESNOTES• Advanced analogue turntable.• Enhanced pitch control. Fast and accurate beat matching adjustment with a 100mm +/-10% fine pitch fader.
4A.S.T.S (Anti Skipping Tone-arm System)The A.S.T.S (Anti Skipping Tone-arm System) was years in trial and development. Initially the quest was to imp
5RearFrontParts and accessoriesPARTSTone ArmArm RestPitch DisplayBalance Weight(Option 5 )Spare Cartridge StandCenter SpindleTurntable Platter(Option
6Turntable AssemblyInstalling the balance WeightSlip matASSEMBLY AND SET-UP• If the player is operated without fixing the screws, theplatter may not r
7r Insert the head shell into the front part of the tone arm. Turnthe looking ring in the direction shown below until the headshell is firmly fixed in
8Connecting Phono terminalPower ConnectionWith the RCA cable (accessory 7) and the GND cable (accessory8), connect the output terminals and the GND te
Kommentare zu diesen Handbüchern